microHAM © 2008 All rights reserved
10. If you use a foot switch, connect the foot switch for RADIO1 to FS1 and foot switch for RADIO2 to FS2.
If you use only a single foot switch, connect it to FS1. You will configure MK2R for single or dual foot
switch operation later with the MK2R control program.
11. MK2R only (not MK2R+) – connect two sound cards to their respective jacks
OUT SC1: connect to the output of sound card 1 (line out or speaker)
MIC SC1: connect to the microphone jack of sound card 1
OUT SC2: connect to the output of sound card 2 (line out or speaker)
IN SC2: connect to the Line In of sound card 2
12. Connect a 12V-16V DC supply to the DC 12V jack.
Be sure to observe the proper polarity.
13. Locate the USB cable but DO NOT connect it it at this time.
16
To Next Page
Loading...
