microHAM © 2008 All rights reserved
Other:
•
configurable Accessory connection with dual BCD band data outputs
•
user definable presets to recall all parameters for different control programs or contests
•
all parameters are stored inside the box memory and reloaded after power up
•
integrated chokes and filters for maximum RFI immunity
•
Metal/Aluminum case, powder coated and silk screened
•
Free, no time limit firmware/software upgrades via Internet
2 - IMPORTANT WARNINGS
ALWAYS check the polarity of the 13.8 V power supply.
When changing Radio #1, ALWAYS be sure the proper microphone for the
radio is connected to the MK2R RJ45 MIC jack BEFORE connecting the DC37
RADIO cable.
If dissimilar radios are attached to MK2R or MK2R+, NEVER connect the
microphone of the Radio #2 to the RJ45 microphone jack on the rear panel.
If your radio supports firmware upload
DO NOT perform any radio upgrade through MK2R.
Remember, under Windows, micro HAM USB Device Router must be running
anytime the interface is used (not just for setup). If Router is not running, the
virtual COM ports will disappear and the device cannot be accessed!
6
To Next Page
Loading...
Need help?
General