What to do if there is no sound from my Microlab Speaker System?
If your Microlab Speaker System has no sound, here are a few things to check: * Ensure the audio source is functioning correctly. * Verify that both the audio and speaker cables are securely connected. * Confirm that the volume is set to an audible level.
Why won't the power LED light up on my Microlab Speaker System?
If the power LED on your Microlab Speaker System doesn't light up, try the following: * Make sure that the system is powered on. * Check that the power plug is properly connected.
Details safety warnings, symbols, and user precautions for safe operation.
Lists essential warnings regarding product operation and maintenance.
Provides step-by-step instructions for safely unpacking the speaker system.
Describes the front and back views of the amplifier and the remote control.
Details the correct sequence and method for connecting system components.
Highlights the key features and design aspects of the speaker system.
Offers solutions for common problems encountered with the speaker system.
General| Type | 2.1 Speaker System |
|---|---|
| Frequency Response | 40 Hz - 20 kHz |
| Signal-to-Noise Ratio | 80 dB |
| Configuration | 2.1 |
| Material | Wooden Subwoofer, Plastic Satellites |
| Subwoofer Power Output | 24 W |
| Satellite Power Output | 15W x 2 |
| Input Impedance | 10 kOhm |
| Satellite RMS power | 15 Watts RMS x 2 |
| Subwoofer RMS power | 24W |
| Signal/Noise ratio | 80 dB |
| Driver Unit | 3" Satellites |
| Power Supply | AC 220V - 240V |
To Next Page
