aponorm
®
Basis Control
17
EN
The memory retains all values although date and time
mustbereset–theyearnumberthereforeashesautoma
-
tically after the batteries are replaced.
Which batteries and which procedure?
Use 4 new, long-life 1.5V, size AA batteries.
Do not use batteries beyond their date of expiry.
Removebatteriesifthedeviceisnotgoingtobeusedfor
a prolonged period.
Using rechargeable batteries
You can also operate this device using rechargeable batteries.
Only use «NiMH» type reusable batteries.
Batteriesmustberemovedandrechargedwhentheat
battery symbol appears. They should not remain inside the
device as they may become damaged (total discharge as a
result of low use of the device, even when switched off).
Always remove the rechargeable batteries if you do not
intend to use the device for a week or more.
Batteries cannot be charged in the blood pressure monitor.
Rechargebatteriesinanexternalchargerandobservethe
information regarding charging, care and durability.
8. Using a Mains Adapter
You can operate this device using the aponorm
®
by microlife
mains adapter (DC 6 V, 600 mA).
Only use the aponorm
®
by microlife mains adapter
available as an original accessory appropriate for your
supply voltage.
Ensure that neither the mains adapter or the cable are
damaged.
1. Plug the adapter cable into the mains adapter socket
4
in
the blood pressure monitor.
2. Plug the adapter plug into the wall socket.
When the mains adapter is connected, no battery current is
consumed.
9. Error Messages
If an error occurs during the measurement, the measurement is
interrupted and an error message, e.g. «ERR 3», is displayed.
Error
«ERR 1»
«ERR 2»
18
Description
Signal too
weak
Error signal
Potential cause and remedy
The pulse signals on the cuff are too
weak.Re-positionthecuffandrepeat
the measurement.*
During the measurement, error signals
were detected by the cuff, caused for
instance by movement or muscle
tension.Repeatthemeasurement,
keeping your arm still.
To Next Page
Loading...
Need help?
General
