10
b) After automatically reaching an individual pressure,
the pump stops and the pressure slowly falls. The cuff-
pressure is displayed during the measurement. If the
inflation pressure is not sufficient, the monitor
automatically re-inflates.
c) When the device has detected your pulse, the heart
symbol in the display begins to blink and a beep tone
is audible for every pulse beat.
d) When the measurement has been concluded, a long
beep tone sounds. The measured systolic and diastolic
blood pressure values as well as the pulse are now
displayed.
e) The measurement results are displayed until you
switch the device off. If no button is pressed for
5 minutes, the device switches off automatically.
5.5. Memory – displaying the last measurement
The measured results are stored in the instrument until a new
measurement is carried out or the batteries are removed.
You can call up the stored values at any time by holding the
START button for at least 3 seconds while the device is off.
5.6. Discontinuing a measurement
If it is necessary to interrupt a blood pressure
measurement for any reason (e.g the patient feels unwell),
the START button can be pressed at any time. The device
then immediately lowers the cuff pressure automatically.
To Next Page
Loading...
Need help?
General
