Other possible malfunctions and their remedies
If problems occur when using the device, the following points should be
checked and if necessary, the corresponding measures are to be taken:
Malfunction
The display remains
blank when the instru-
ment is switched on.
The device frequently
fails to measure blood
pressure values, or the
values measured are too
low (too high).
Every measurement pro-
duces a different value.
Blood pressure values
measured at your doctors
office differ from your
measurements.
17
Remedy
1. Check batteries for correct polarity.
2. If the display is unusual, re-insert batter-
ies or exchange them.
1. Check the positioning of the cuff.
2. Measure blood pressure again in peace
and quiet carefully following the details
in Section 5.
1.Please read the following information
listed in Section 5.2
"Common sources
of error
."
Repeat the measurement.
Please note: Blood pressure fluctuates
continually so successive measure-
ments will show some variability.
1.Record the daily development of the
measured values and consult your doctor.
Please note: Individuals visiting their
doctor frequently experience anxiety
which can result in a higher reading
than at home under resting conditions
.
To Next Page
Loading...
Need help?
General
