Microlife IR 1DE1 - Directions for Use

7
7. Directions for Use
Important: Prior to every measurement, fit a new undamaged Probe
Coveronthemeasuringprobe.Failuretodosomayresultinincorrect
temperaturemeasurement.
1. PresstheO/Ibutton.Thedisplayisactivated
toshowallsegmentsfor2seconds.
2. Thelastmeasurementreadingwillautomati-
callybeshownonthedisplayfor2seconds
withthe«M»icon.
3. Whenthe «°C»or«°F»iconisflashing,a
beepsoundisheardandthethermometeris
readyformeasurement.
4. Straightentheearcanalbypullingtheearupandbacktogivea
clearviewoftheeardrum.
• Forchildrenunder1year;pulltheearstraight
back.
• Forchildrenof1yeartoadult;pulltheearup
andback.
Alsorefertotheshortinstructionsatthefront.
5. Whilegentlypullingtheear,insertthe
probesnuglyintotheearcanal(max. 1 sec.)
andimmediatelypresstheSTARTbutton.
Releasethebuttonandwaitforthebeep
sound.Thisistheindicationthatconfirms
theendofmeasurement.
6. Removethethermometerfromtheearcanal.
Thedisplayshowsthemeasuredtemperature.
NOTE:
To ensure accurate readings, wait at least 30 sec. after 3-5
continuous measurements.
EN