SUSE 11.x x64
Before you begin, locate the appropriate ISO file you will need for the service pack ver-
sion of SUSE installed in the system. (This file is contained with the support pack soft-
ware in the Linux Driver subdirectory.)
• For SP3: mtip32xx-kmp-default-<driver_version>_3.0.76_0.9-1.x86_64.iso
• For SP2: mtip32xx-kmp-default-<driver_version>_3.0.13_0.27-1.x86_64.iso
• For SP1: mtip32xx-kmp-default-<driver_version>_2.6.32.12_0.7-1.x86_64.iso
1. Extract the correct ISO image and copy it to a USB drive or burn it to a CD.
To copy to a USB drive, you must use a CD burning tool (such as Daemon Tools or
Nero) that allows you to view the contents of the ISO image so that it can be ex-
tracted to the USB drive. A USB drive is recommended, unless your system con-
tains two CD-ROM drives.
Note: You can use the following dd command to extract the files to the USB drive;
however, this command removes any existing data on the USB drive and replaces
it with the extracted ISO image contents:
dd if=<mtip32xx-kmp-default-<kernel_version>.x86_64.iso of=/dev/sdX
where /dev/sdX is the device path of the target USB drive
If the USB drive contains important files, it is highly recommended to back up the
files on alternate media before using this command.
2. Insert the SUSE boot CD/DVD and USB drive containing the P420m/P320h driver
image into the system and reboot.
3. When the initial installation screen appears, press F6 and select Yes.
4. Select the USB drive when prompted for the driver, and then select OK.
The driver files are installed. When complete, the installer returns to the same
screen prompt.
5. Select Back to continue the installation.
6. Remove the USB drive.
The installation continues and may take several minutes to complete.
7. Select the Expert Settings tab when the Installation Settings menu displays.
8. Select the Bootloader Installation option.
9. Verify grub is the boot loader type and change the default boot location from Boot
from Boot Partition to Boot from Master Boot Record.
Make sure only the Boot from Master Boot Record option is selected.
10. Click Next and verify the Bootloader was installed successfully message appears.
11. Click OK and then Finish.
The installer displays two messages confirming the new settings.
12. Select I agree, and then Yes for each.
13. Select Reboot.
If an installer error message displays, click OK and select Exit or Reboot twice to
reboot the system. The CD can remain in the system.
14. When the system reboots, boot from the CD/DVD.
15. Select Boot from Hard Drive when prompted. Make sure that no other bootable
media is connected to the system to make sure the system boots from the SSD.
The system should boot from the OS on the SSD.
16. Remove the CD from the system.
17. Reboot the system again and make sure the system boots directly from the SSD
without the installer CD.
P420m/P320h HHHL PCIe SSD Installation Guide
Using the P420m or P320h as a Boot Drive
PDF: 09005aef8497e00a
P420m_P320h_HHHL_installation_guide.pdf - Rev. V 12/14 EN
25
Micron Technology, Inc. reserves the right to change products or specifications without notice.
© 2012 Micron Technology, Inc. All rights reserved.
To Next Page
Loading...
