Microplex SOLID F40 - Page 116

116 Operator Maintenance
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
Transfer charger
Transfer elevator
drive shaft
!
3. Turn to loosen the knob screw of the transfer-/separator charger
and pull the transfer-/separator charger out towards you.
Knob screw
Transfer-/separator charger
4. Replace the new transfer-/separator charger in its original
position and fasten up the knob screw to secure the charger.
5. Close the waste toner recovery unit.
Make sure the bar has engaged.
6. Close the printer’s front cover.