Microplex SOLID F40 - Error Messages

Troubleshooting 129
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
8.2. Error Messages
[Error message ]
[Error code ]
[COVER OPEN! ]
[E0001 ]
[PAPER END! ]
[E0002 ]
[PAPER JAM! ]
[E0003 ]
[PAPER JAM! ]
[E0004 ]
[PAPER JAM! ]
[E0005 ]
[PAPER JAM! ]
[E0007 ]
[PAPER JAM! ]
[E0011 ]
[PAPER JAM! ]
[E0012 ]
In the following the individual error messages that may appear on
the display are shown in the following systematic manner:
Short description
Remedy
The front cover has not been closed completely.
Please close it completely.
There is no more fanfold paper on the tractor.
Replace the fanfold paper (see section 3.1).
Paper jam in the fusing section.
Remove the jammed paper (see section 8.3).
Paper jam behind the fusing section.
Remove the jammed paper (see section 8.3).
Paper jam in the exit unit.
Remove the jammed paper (see sections 8.3).
1) Knob "B" (scuff roller) is free.
Turn knob "B" counterclockwise to lock (see section 8.3.2).
2) The paper path is open.
Use the green lever to close the paper path (compare section
8.3.2).
There is still paper within the separator unit.
Remove the paper (see section 8.3).
There is still paper within the fuser unit.
Remove the paper (see section 8.3).