Microplex SOLID F40 - Page 132

132 Troubleshooting
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
Error code
E0050
E0051
E0052
E0053
E0054
E0055
E0056
E0057
E0058
E0059
E005A
E005B
E005C
Description
Communication error at the power stacker (overrun error)
Communication error at the power stacker (parity error)
Communication error at the power stacker (framing error)
Communication error at the power stacker
Error at the locking device of the power stacker
Fanfold paper is not folded
Stacker is full
Stacker is not ready
No auto mode
Stacker capacity is exceeded
Motor rotation is not normal
Power stacker is active
Error at the stacker