Microplex SOLID F40 - Page 59

Panel Functions 59
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
5.12. Print Direction Selection
This function selects the active print orientation (orientation of the
whole printout including graphics, etc. on the paper).
ON LINE
SAVE
SAVE
SAVE
MENU
SAVE
ON LINE
Panel display
[SOLID F40 ]
[Menu Level 1 ]
) ) )
[Paper Menu ]
[Page Length ]
) ) )
[Print Direct. ]
[Print Direct. 0
]
) ) )
[Print Direct. 1 ]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press one of the ARROW keys until
[Paper Menu ] is displayed.
Press one of the ARROW keys until
[Print Direct. ] is displayed.
Press the NEXT or PREVIOUS key until
the desired print direction is displayed.
The print direction 1 = landscape is
selected.
In addition this new value can be saved
as setup value (using the SAVE key),
before the printer is turned ON LINE
again.
Print direction assignment: Print direction 0 = Portrait (upright format)
Print direction 1 = Landscape (horizontal format)
Print direction 2 = Portrait upside down
Print direction 3 = Landscape upside down