58 Panel Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
5.11. Paper Width Adjusting (Format Width)
This function is used to adjust the format width (print width) to the
actually used paper format.
ON LINE
SAVE
SAVE
SAVE
SAVE
MENU
SAVE
ON LINE
Panel display
[SOLID F40 ]
[Menu Level 1 ]
) ) )
[Paper Menu ]
[Stacker Select ]
) ) )
[Paper Width ]
[in inch ]
) ) )
[Digit4 08.51]
) ) )
[Digit1 08.53
]
[Save as Setup? ]
Notes
Turn the printer OFF LINE with this key.
Press one of the ARROW keys until
[Paper Menu ] is displayed.
Press the SAVE key to select the paper
menu.
Press one of the ARROW keys until
[Paper Width
] is displayed.
Press the SAVE key to adjust the format
width to the paper width.
Inch = currently selected measuring unit
(alternative the measuring units mm or
1/300 inch can be chosen with the ARROW
keys).
Pressing one of the ARROW keys changes
the value of the current position
(Digit4 = left digit, in this example: 0).
Pressing the SAVE key moves you to the next
digit (the MENU key moves you back). The
maximum adjustable format width is 14.72
inches.
The format width is changed to 8.53 inches.
In addition this new value can be saved as
setup value (using the SAVE key), before the
printer is turned ON LINE again.
Note: Information for „Paper Request“ can be found in section 5.9 Page Length Adjustment.
To Next Page
Loading...
