Microplex SOLID F40 - Configuration of Network Parameters (IP Address, e.g.)

80 Panel Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
5.28. Configuration of Network Parameters (IP Address, e.g.)
The functions of the submenu Network are used to set the parameters for
connecting the printer to a network (Ethernet).
Setting the IP address manually:
ON LINE
SAVE
SAVE
SAVE
SAVE
SAVE
SAVE
ON LINE
Panel display
[SOLID F40 ]
[Menu Level 1 ]
) ) )
[Network ]
[Timeout ]
) ) )
[Ethernet ]
[Duplex/Speed
]
) ) )
[IP Assign ]
[Off ]
) ) )
[Manual ]
[IP Address ]
[192.168.002.002 ]
) ) )
[192.168.010.123 ]
[Saved ! ]
Notes
Turn the printer OFF LINE with this key.
Press one of the ARROW keys until
[Network ] is displayed.
Press the SAVE key to select the Network
menu.
Press one of the ARROW keys until
[Ethernet ] is displayed.
Press the SAVE key to select the
IP Ethernet menu.
Press one of the ARROW keys until
[IP Assign ] is displayed.
Press the SAVE key to select the
IP Assing menu.
The current setting value is displayed.
Press one of the ARROW keys until
[Manual ] is displayed.
Press the SAVE key to set the
IP address manually.
Pressing one of the ARROW keys changes
the value of the current digit (left digit first,
in this example: 1). Pressing the SAVE key
moves you to the next position (the MENU
key moves you back, if need be).
The new IP address is saved as setup
value.
The printer is turned ON LINE again.