Microplex SOLID F40 - Page 81

Panel Functions 81
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
Notes:
If your network is using DHCP
*
, an address can be automatically
assigned (select the item
DHCP from the network submenu
IP Assign).
The parameters
Subnet Mask and Gateway are configured in
the same way as described above. Please select the concerning
panel functions for this (compare section 5.7 Menu Structure).
Select the subitem
Off from the network menu to switch off the
network access.
*
Dynamic Host Configuration Protocol: offers among other things
a centralized address management.