Microplex SOLID F40 - Cleaning the Elements behind the Front Cover

84 Printer Cleaning
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
6.1. Cleaning the Elements behind the Front Cover
1. Turn off the SOLID F40 printer and pull the power plug.
Make sure, the printer has been switched off for at least
15 minutes before you start cleaning the device.
2. Open the front cover of the printer.
Handhold
Fron
t
cover
3. Using an anti-static service vacuum cleaner, clean up
toner, paper dust or other particles which may have
accumulated.
4. Push down the open lever of the waste toner recovery unit,
and open the unit.
Waste toner
recovery unit
Open lever (black)