Microplex SOLID F40 - Page 94

94 Operator Maintenance
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
7.1.1. Main Charger Cleaning
Turn off the printer and pull the power plug before start working
at the chargers.
1. Open the front cover of the printer.
Handhold
Fron
t
cover
2. Turn the knob screw of the main charger (C1) to loosen it.
Then pull the charger towards you.
Main charger (C1)
Knob scre
w
3. Place the charger on a clean and level worktop.