Microplex SOLID F40 - Page 95

Operator Maintenance 95
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
!
4. Remove the grid from the main charger. For this please push
on the tab and remove the grid.
5. Place the grid on a level worktop that has been covered by
a few sheets of clean paper.
6. Hold the grid firmly in the centre.
7. Using the Emery block, clean the grid in the following
manner:
• Place the Emery block on the centre of the grid.
• Apply light pressure.
• With a single outward motion, move the block towards the
end of the grid.
• Repeat this action 10 times.
• Repeat the actions described above for the second half of
the top side and for the two halves of the reverse side, too.
After three complete cleanings of the main charger grid, the
emery paper sheet of the block has to be removed.