Microplex SOLID F40 - Page 96

96 Operator Maintenance
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual SOLID F40 Edition 1.1
8. Clean the housing of the main charger using the blower brush.
9. Turn the charger round and clean the wires from its reverse
side using the wire cleaning tool. After this process the wires
should be completely smooth.
10. Reassemble the grid to the main charger (compare item 4).
11. Replace the main charger in its original position and tighten
the knob screw.
12. Close the printer’s front cover.