Statistics
The charger is collecting charger data for data
analysis and service. The data can be accessed
through Service Tool or GET Cloud.
Safety shut-off
Charging can be terminated if:
•
The recharged number of ampere-hours
exceeds the preset value.
•
The charging time for any of the charging
phases exceeds the preset value.
•
Voltage and current exceed the maximum set
value.
•
The battery is disconnected without the
battery charger being stopped.
•
The BMS turns off the battery charger via
CAN bus.
•
The CAN bus communication with the battery
is interrupted.
Charging is temporarily stopped or reduced when:
•
The battery charger temperature exceeds
charger limits.
•
The BMS stops or reduces the charging via
CAN bus.
Checking error messages
When the battery charger detects a fault:
•
the alarm indicator is lit on the battery charger
control panel. See Control panel pos 2.
•
an error message is displayed in the control
panel display. If there is more than one error
message, they are automatically scrolled.
Make a note of the information and call service
technician.
Checks
The following are recommended to be done
regularly:
1. Check the cables and connectors for
damages.
2. Check that the battery is free from defects, in
good condition and is the correct type for the
battery charger.
3. Check that the BMS and battery are properly
connected and that the battery fuse, if any, is
not broken.
4. Check that the mains voltage is correct and
that there are no blown fuses.
Technical data
Operational ambient temperature: 0 to 40 °C (32
to 104 °F)
(1)
Storage temperature: –25 to 60 °C (–13 to
140 °F)
Mains voltage: See data label
(2)
.
Battery types: Li-ion
Output voltage: See data label
(2)
.
Recommended battery capacity:
Min capacity = DC output current × 1.25 Ah
Max capacity = DC output current × 5 Ah
Efficiency: > 90 % at full load.
Ingress protection: IP20
Connectivity options:
Radio: 2.4 GHz (2405–2475 MHz)
NFC: 13.56 MHz
Approvals: CE and/or UL. See data label
(2)
.
FCC: Z7H-EMB2538PA IC: 21487-EMB2538PA
1) Measured at the charger air inlet.
2) Located on the battery charger.
Recycling
The product is recycled as electronic scrap. Local
regulation apply and should be followed.
Contact information
Micropower Group AB
Idavägen 1, SE-352 46 Växjö, Sweden
Phone: +46 (0)470-727400
e-mail: support@micropower.se
www.micropower-group.com
Approvals
Manufactured by: Micropower Group AB
The manufacturer declares that this product
complies with applicable requirements and the
Radio Equipment Directive 2014/53/EU.
Complete declaration is available at Micropower
Support Center: https://docs.micropower-
group.com/Other docs
ENGLISH
9
To Next Page
Loading...
