Using the Remote Control Learning Functionality
The TV, VOL +, and VOL – buttons on the remote control for Media Center PC can
“learn” IR commands from other remote controls. This feature lets you use the TV
button to turn on your TV and the VOL + and VOL - buttons to adjust the volume on your
TV or another device, such as an audio receiver.
Notes
• By default, the VOL + and VOL - buttons on the remote control for Media Center PC
control the system volume on your computer, and the TV button has no command
assigned to it until it “learns” one.
• Do not perform this procedure in bright natural or articial light.
To program buttons on the remote control by using the learning feature
1 Place the remote control for Media Center PC head to head (2 to 3 inches apart)
with the remote control from which it is learning.
2 On the remote control for Media Center PC, press and hold the DVD MENU and OK
buttons at the same time until the remote control lights turn off
(2 seconds).
The remote is now in learning setup mode.
3 On the remote control for Media Center PC, press and release the TV,
VOL +, or VOL – button, depending on which command you want it to learn.
The remote control for Media Center PC lights blink once to conrm the selection.
4 On the remote control that is teaching the command, press and hold the button that
you want the corresponding button on the remote control for Media Center PC to
learn.
The remote control for Media Center PC lights blink twice to conrm the selection.
If the remote did not learn the command, the lights blink quickly four times. To try
again, repeat steps 1 through 4.
5 Repeat steps 1 through 4 for the other buttons that can learn commands.
To restore the default remote control settings
1 Press and hold the DVD MENU button and LEFT navigation button at the same time
until the remote control for Media Center PC lights turn off.
2 Press the OK button.
The remote control for Media Center PC lights blink twice to conrm that the buttons
have been reset. The TV button will have no command assigned to it and the VOL +
and VOL – buttons will adjust the Media Center PC system volume.
If the default settings were not restored, the lights blink quickly four times. To try
again, repeat steps 1 and 2.
To Next Page
Loading...
Need help?
General
