Microsoft Remote Control and Receiver Getting Started Guide

9
Regulatory Information
Tested to comply with FCC Standards. For home or ofce use. Not intended for use
in machinery, medical or industrial applications. Any changes or modications not
expressly approved by Microsoft could void the user’s authority to operate this device.
This product is for use with NRTL Listed (UL, CSA, ETL, etc.), and/or IEC/EN 60950
compliant (CE marked) Information Technology equipment. No serviceable parts
included.
This device is rated as a commercial product for operation at +41ºF (+5ºC) to +95ºF
(+35ºC).
This Class B digital apparatus complies with Part 15 of the U.S. Federal
Communications Commission (FCC) rules, Canadian ICES-003 and RSS-210.
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
Cet appareil numérique de la classe B est conforme aux normes NMB-003 et CNR-
210 du Canada. Son fonctionnement est assujetti aux deux conditions suivantes : (1)
Cet appareil ne peut pas provoquer d’interférences nuisibles et (2) cet appareil doit
accepter toute interférence reçue, y compris les interférences pouvant entraîner un
fonctionnement non désiré.
Microsoft Corporation; One Microsoft Way; Redmond, WA 98052-6399; U.S.A. United
States: (800) 426-9400 Canada (800) 933-4750
Important Battery Information
Caution Use and replace only with AA (LR6) Alkaline, Carbon-Zinc, or Zinc-Chloride
batteries.
General Precautions
• Keep batteries out of reach of children.
• Insert the batteries in the proper direction as indicated by the positive (+) and
negative (-) markings on the battery and battery compartment.
• Do not mix old and new batteries or batteries of different types (for example, carbon
and alkaline batteries).
• Always remove old, weak, or worn-out batteries promptly and recycle or dispose of
them in accordance with Local and National Disposal Regulations.
• If a battery leaks, remove all batteries and recycle or dispose of them in
accordance with the battery manufacturer’s instructions and Local and National
Disposal Regulations. Before inserting new batteries, thoroughly clean the battery
compartment with a damp paper towel, or follow the battery manufacturer’s
recommendations for cleanup. If uid from the battery comes into contact with skin
or clothes, ush skin with water immediately.
• Remove the batteries if your device is to be stored for an extended period of time
without being used.
X107247302mnl.indd 8/9/2004, 11:31 AM9

Microsoft Remote Control and Receiver Specifications

General

Brand	Microsoft
Model	Remote Control and Receiver
Category	Remote Control
Language	English