3. Remove PSA
If you’re reusing the Top Case, we recommend peeling off the PSA off with a pair of
tweezers. Clean any residue with isopropyl alcohol and a cotton swab to ensure a clean
surface for new application.
Procedure – Installation (Top Case, Xbox Elite Series 2
Controller)
1. Install PSA
If you are reusing the Top Case, apply the four strips of PSA inside the inner part of the top
case of the controller. You should see upon the removal where the previous PSA strips were
at.
2. Install Top Case
When installing the new Top Case, align with the D-pad and thumb stick openings and
simply press down onto the device, working around the edge to lock all snaps into place.
There should not be any gaps or openings around the seam of the device once you are
complete.
To Next Page
Loading...
