4. Install Palm Motors
Gently press each palm rumble motor into the mid-frame. A plastic pry tool may be
required to gently bend the retention clip back.
5. Route Wires
Repeating in reverse step 6 of the removal instructions, reroute the trigger motor wires
through the side clip, and through the mid-frame retention tabs up to the triggers.
6. Install Trigger Motors
Install the trigger motors in the housing, with wires facing towards the center of the
mid-frame.
IMPORTANT: Leave about 1 in. (25mm) of wire on the mainboard portion of the
wire route to ensure wire length at the triggers is short enough to not be pinched
at a later step.
NOTE: The motors are soldered to the main board. This solder connection is very
fragile at both the motor and board ends. Take care not to damage the soldered
connection.
NOTE: The motors are soldered to the main PCBA. This solder connection is very
fragile at both the motor and PCBA ends. Take care not to damage the soldered
connection.
To Next Page
Loading...
