9. Install Antennas
Position the left antenna on the left connector on the mainboard and press down to
connect. Repeat this process for the right antenna.
10. Install D-Pad
Install D Pad back on the mid frame if the retaining clip has been taken off. If not, proceed
to step 11.
11. Install Mid-frame
Install the mid-frame as detailed in the Procedure – Installation (Mid-frame) (page 20)
12. Install Top Case
Install the top case as detailed in the Procedure – Installation (Top Case) (page 14)
NOTE: The wires and pads on the mainboard are fragile. Take caution not to break
the pads from the mainboard.
To Next Page
Loading...
