Place the I/O board in the mid frame.
2. Install Screws
Using a T6 (Torx) driver install the 4 screws securing the I/O board to the mid-frame. Turn
each screw until finger tight then tighten by an additional 1/8 turn (45-degrees) or until fully
fastened.
3. Install Mainboard
Install the Mainboard as detailed in the Procedure – Installation (Mainboard) (page 39)
4. Install Mid-frame
Install the mid-frame as detailed in the Procedure – Installation (Mid-frame) (page 20)
5. Install Top Case
Install the top case as detailed in the Procedure – Installation (Top Case) (page 14)
To Next Page
Loading...
