Microtek ScanMaker 1000XL - Page 19

ScanMaker 1000XL Supplement 19
3. Go to the Preview window of
ScanWizard Pro, and choose
Reflective from the Scan Material
menu.
4. Optional: If calibration has been
performed, go to the Settings window
in ScanWizard Pro. Choose the profile
you have just created in the Input
Profile / Scanner Profile menu.
For more details, see the section
“Loading a Profile” in the MSP
section of the manual.
Note: The MSP program should be installed before you perform color
calibration for your scanner. For details on how to install the MSP program
and how to use it to calibrate the scanner, refer to section of the manual
titled “Using the Microtek Scanner ICC Profiler”.
• Next, you will be prompted to set up color matching for your scanner. If you
are not sure about what to do, simply click the OK button to accept the
settings. You can always change the settings at a later time.
For more information, see the Color Matching Setup section in the
ScanWizard Pro Reference Manual in the Microtek CD.
Color Matching
features