Microtek SineWave UPS EB - BACK PANEL

5
6
1
4
1. MainsInput LeadforAC input.
2. Circuit Breaker (7Amp for UPS SWE² 625 model, 10Amp
for Sinewave UPS SWE² 875 model, and 15 Amp for
Sinewave UPS SWE² 1550 model.) for Mains overload/
Short CircuitProtection.
3. Output socket for load.
4. Fuse (10Amp. Slow Blow) for UPS.
5.
(+) Positive Battery Lead.
In case of Sinewave UPS SWE² 625/875 : 12V Batt. Sys.
6.
(-)Negative Battery Lead.
In case of Sinewave UPS SWE² 1550 :24V Batt. Sys.
7. Slide Switch for Mains Input Voltage Range Selection.
2
7
BACKPANELOF MODELS:
SINEWAVE UPSSWE² 625/ 875/ 1550
3
7
BACK PANEL