Page 4 of 9
3. Set time required
Press button after the
temperature setting and the
time light is ON. Press Up “△” or
Down “▽” button to set time
according to different transfer
material.
Press button after time setting;
the display shows the temperature
starts to rise. “CD-L” shows the time
counting down during your transfer.
If there is a difference between the
actual temperature and temperature
shows on the controller, you can
use P5 mode to calibrate the
difference.
For example, when actual heat
platen temperature is 180 °C but the
display shows 200°C, press
button for 5 seconds to enter the P5
mode. When enter P5 mode,
press UP button
“
△
”to
set to 20,
and then press button again
for 5 seconds return to operation
mode. In the contrast, when actual
heat platen temperature is 200 °C
but the display shows 180°C, press
4. Printing Methods
Step 1: Make sure the cord is connected well to the wall socket. Lift up the handle to open the press. The
press should always be in the open position when the press is heating. Place the object (i.e. T-shirt , Mouse
Pad etc) and transfer paper with images facing down the object on under plate; adjust the pressure to be
moderate and switch on the press.
Step 2: Temperature indicator light is on. Set the temperature according to different transfer material.
Recommended temperature is 180°C~200°C
Step 3: Then set the time according to different transfer material.
Step 4: When the temperature rise to the set temperature, the buzzer sends out sounds; then close
down heat platen (meantime the sounds stop) and starts to transfer.
To Next Page
Loading...
Need help?
General