It is po ssible to “pick up” all the faders and
then set them to 0dB if adjustment is not
required. There is no need to “clear” them.
This is a user preference.
If faders are not cleared pri or to recalling a
new scene it may be advisable to clear
them immediately aft erwards to avoid
confusion.
Any virtual fader can be isolated from
further scene recall by pressing the
AUTOmation SAFE switch. After the
switch is pressed it will also be possibl e to
“pick up” the virtual fader at the recalled
posit ion and adjust it using the real fader
(exactlythesameasforstoremode).Any
subsequent scene recall will have no effect
on the virtual fader position.
Any virtual fader can be isolated from
further scene recall by pressing the
AUTOmation SAFE swi tch. After the
switch is pressed it will also be possibl e to
“pick up” the virtual fader at the recalled
posit ion and adjust it using the real fader.
Any subsequent scene recall will have no
effect on the virtual fader position.
To regain virtual fader control switch the
AUTOmation SAFE switch off and then
recall the current (or nex t required) scene.
Virtual fader control will resume as the
scene is recalled. The fader wi ll not be
“pickedup”andcanbemovedto-infinif
desired as long as it does not pass through
0dB. If it does pass through 0dB it will
“pick up” in the normal way.
To regain virtual fader control switch the
AUTOmation SAFE swi tch off an d then
recal l the current (or next required) scene.
Virtual fader control will resume as the
scene is recalled. The fader wi ll not be
“pickedup”andcanbemovedto-infinif
desired as long as it does not pass through
the virtual fader position. If it does it will
“pick up” in the normal way.
Any input channel virtual fader can be
totally isolated by pressing the FADER
SAFE switch. At this point the virtual fader
will "snap " to match the real fader po sition
and any master VCA and automation
control will be removed. To regain virtual
fader control switch the fader safe off and
recall a new scene. The real fader can th en
beclearedto-infininthenormalway.
Any input channel virtual fader can be
totally isolated by pressing the FADER
SAFE switch. At this point the virtual fader
will "snap " to match the real fader po sition
and any master VCA and automation
control will be removed. To regain virtual
fader control switch the fader safe off and
recall a new scene. The real fader can th en
beclearedto-infininthenormalway.
It is not possible t o sto re a scene in this
mode. The m ain reason this is not all owed
is because multiple ov erstores of faders
which have adjust ments made would result
in incremental virtual fader posit ion
changes which in most cases would not be
desired.
When storing a scen e the inform ation
loaded in to th e scene memory will always
be as displayed by the leds. This still
appliesifafaderisisolatedbythefader
safe or automati on safe switches.
41
To Next Page
Loading...
Need help?
General
