Installing FireWire on a PC 23
VeniceF
Operator Manual
>> To change the FireWire settings
Use the drop-down lists and buttons on the Midas FW settings screen to change the
FireWire settings, as desired, using the following diagram and the accompanying list of
associated elements to guide you.
Note: The settings available for configuration may be dependent on a number of
variables, such as the hardware specification of the PC, the type of operating system
you are using, the recording software application, etc. The setting you may want to
adjust may be available for change in the recording software application itself.
Mains elements of a typical Midas FW screen (PC version)
Item Element Description
1 WDM button
The WDM
1
button lets you select a different audio
device driver, such as Sonar.
2 Sample Rate
drop-down list
This drop-down list lets you select the sample rate
(samples per second) for the VeniceF. Options are
44.1kHz and 48kHz.
3 Info button Use this button to check the software version of the
driver.
4 Master drop-down
list
This drop-down list shows the clock source. (This will
be always be set to Venice.)
To Next Page
Loading...
