Need help?Do you have a question about the Midas VERONA and is the answer not in the manual?
General| Type | Analog |
|---|---|
| Stereo Line Inputs | 4 |
| Aux Sends | 8 |
| Groups | 8 |
| Subgroups | 8 |
| Faders | 100 mm |
| USB Audio Interface | No |
| Number of Channels | 32 |
| Mic Inputs | 24, 32, 40 |
| Frequency Response | 20 Hz to 20 kHz |
| EQ Bands | 4-band |
| Frame Sizes | 24, 32, 40 channels |
| Total Harmonic Distortion | <0.01% |
| Dimensions | Varies by frame size |
| Weight | Varies by frame size |
Users must read, retain, and follow all safety instructions and warnings.
Avoid water, blockages, heat sources, and use specified accessories.
Protect power cords, unplug during storms, and refer servicing to qualified personnel.
Guidelines for power supply connection, grounding, and audio cable selection.
Details rear panel connections and gain adjustments for mono input channels.
Explains the four-band sweep EQ for tonal control on mono channels.
Details rear panel connections and primary input controls for multi-function channels.
Explains the EQ stages available on multi-function input channels.
Flexibility switch for routing aux signals to group controls.
Explains group aux changeover and pre/post fader selection.
Special solo mode for sound checks, muting un-soloed channels.
Advice on setting input gain for optimal signal-to-noise ratio.
Importance of headroom for preventing signal overload.
Recommendations for using EQ without compromising signal integrity.
Operating modes like FOH, Monitor, and Dual FOH/Monitor.
Information on internal/external power supplies and redundancy options.
Procedures and warnings related to servicing and maintenance.
To Next Page
