Product Features
Page 31
ECO/GEAR Function
NOTE: This function is only available under COOL mode.
Press ECO/GEAR button to enter the energy
efficient mode in a sequence of following:
ECO -->GEAR(75%) -->GEAR(50%) --> Previous setting
mode -->ECO......
ECO operation:
Under cooling mode, press this button, the remote
controller will adjust the temperature automatically to
24
O
C, fan speed of Auto to save energy(but only if the
set temperature is less than 24
O
C). If the set temperature
is above 24
O
C , press the ECO button, the fan speed
will change to Auto, the set temperature will remain
unchanged.
NOTE:
• Pressing the ON/OFF button, modifying the mode or
adjusting the set temperature to less than 24OC will
stop ECO operation.
• Under ECO operation, the set temperature should be
24OC or higher. it may result in insufficient cooling.
If you feel uncomfortable, just press the ECO button
again to stop it.
GEAR operation:
• Press this button to enter the energy efficient mode in
a sequence of following:
• This function is only available under COOL mode.
• Under GEAR operation, the display on the remote
controller will alternate between electrical energy
consumption and set temperature.
TEMP Button
Press and hold and buttons together for 3 seconds
will alternate the temperature display between the
O
C &
O
F scale.
FP Function
When the air conditioner operates under heating mode
with the set temperature of 16
O
C(60
O
F), pressing
button twice in two seconds will activate 8
O
C(46
O
F)
heating. The indoor unit display shows “FP“.
Silence Function
Hold down Fan speed button( ) for 2 seconds to activate/
cancel Silent mode.
Boost Function( )
The Boost function makes the unit work extra hard to
reach your present temperature in the shortest amount of
time possible.
Swing Button
Used to stop or start vertical louver movement and set
the desired left/right air flow direction. The vertical louver
changes 6 degree in angle for each press. If keep pushing
more than 2 seconds, the vertical louver auto swing
feature is activated.
Swing Button
Used to stop or start horizontal louver movement or
set the desired up/down air flow direction. The louver
changes 6 degree in angle for each press. If keep pushing
more than 2 seconds, the louver will swing up and down
automatically.
NOTE: When the unit is off, press and hold Mode and
buttons together for one second, the louver will open
for a certain angle, which makes it very convenient for
cleaning.
Press and hold Mode and buttons together for one
second to reset the louver.
To Next Page
Loading...
Need help?
General
