Page 27
Operating
Instructions
(With Remote)
NOTE
This equipament has been tested and found to comply with the limits for Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipament generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipament does cause
harmful interferance to radio or television reception, which can be determined by
turning the equipament off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
4) Consult the dealer or an experience radio/TV technician for help.
Changes or modifications not approved by the party responsible for FCC compliance
could void the users authority to operate the equipment.
This appliance complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that
may cause undesired operation.
ENERGY SAVER OPERATION
In this mode, the fan will continue to run for 3
minutes after the compressor shuts off. The fan then
cycles on for 2 minutes at 10 minute intervals until
the room temperature is above the set temperature,
at which time the compressor turns back on and
cooling resumes.
1
To Next Page
Loading...
