Midea M Series

10
ITEM PICTURE HOW TO DISASSEMBLE
6 Take down the back
control panel, cover
switch, water inlet
valve,water
level sensor,
and internal wire
subassembly
Use cross screwdriver
and vice
①Remove the back control
panel screws, and take out
the back control panel.
②Remove the cover switch
screws.
③Take down the water inlet
valve.
④
Remove the water level
sensor Screws.
⑤Take out the internal wire
Subassembly
.
7 Door Lid
Use cross screwdriver
①
First remove the door
bolt.
②
Take down the lid
③
Take out the spring
8 outer tub cover
Use cross screwdriver
Unscrew the outer tub
cover screws, and take out
the outer tub cover
9 Impeller
Use cross screwdriver
Unscrew the impeller
screws, and take out the
impeller
10 Spin tub
use sleeve
Unscrew the spin tub bolts
and take out the spin tub
cover
3 UNPACKING WAYS OF MAIN PARTS