11
Fault Analysis of possible causes Countermeasure
“Tap water light,
Purified water
light, 85ºC Keep
warm light"
flashes
“Tap water light,
Purified water
light, 45ºC Keep
warm light, 85ºC
Keep warm light"
flashes
• Sensor ultra high
temperature protection
• Add water into the kettle and
reconnect to power supply,
or send to after-sales services
• Reconnect to power supply
or send to after-sales services
• Sensor failure protection
Circuit Principle Diagram
Reminder
The electrical wiring is subject to change without prior notice.
Red wire
Yellow-green
wire
Liner
housing
Thermal
fuse
Blue wire Blue wire
White wire
Thermostat
Heating pipe
Power panel
Control
board
Red wire
Black wire
Care and cleaning
Reminder
• Before cleaning, please ensure the power plug has been disconnected and the electric water kettle has been
cooled down.
• To extend the lifespan of the electric water kettle, please clean the mineral deposits (scale) inside the kettle,
you may apply cleaning agent (such as vinegar, citric acid) to clean.
• There might be a minor odour after each cleaning, you may fill the kettle with cold water, boil the water few
rounds and drains off the water to remove the odour.
• Do not rinse the kettle exterior with water, do not use steel balls, chemical or powdering detergent to clean the
exterior.
• Use water-containing sponge to wipe the liner, do not use detergent powder, grass brush or nylon brush.
• Do not dry the kettle with dishwasher or dryer, otherwise the kettle will be deformed and damaged
Daily Maintenance
Please keep the kettle clean after each use. For prolonged storage,
please unplug the power from the outlet, and apply necessary moisture,
dust and pest prevention methods.
Product Specification
Model Volume
5.0L 750-900W
220-240V~
50-60Hz
Voltage frequency Rated power
MA5021D
Product size Net weight
310x224x304mm
(LxWxH)
2.16kg
To Next Page
Loading...
