19
5 TROUBLESHOOTING
(1) If the power is off or the fuse is burned out.
(2) If the water supply is cut off or the water pressure
is too low.
(3) If the inlet hose is properly connected and the
water tap is opened.
(4) If the filtering screen of inlet valve is blocked by dirt.
(5) If the coil of inlet valve is damaged. (The slight
electromagnetic sound is normal phenomenon when
the inlet valve is switched on)
(6) If the "Start / Pause" button is pressed after the
power switch is pressed.
(1) If the power is off or the fuse is burned out.
(2) If the power supply voltage is too low.
(3) If the water amount reaches to the required water
level. (The washer will not work if the water amount
does not reach the required water level)
(4) If it is set to "Delay" washing mode. (It will only
start to work until the reservation time reached)
(1) If the water drain hose is placed very high.
(2) If the end of water drain hose is sealed in pond.
(3) If the internal rubber ring of drain valve is blocked
by dirt.
(1) If the door lid is closed.
(2) If all clothing piled largely at one side of barrel or
the clothing is excessively placed.
(3) If the washer is not placed in stable condition or it
is placed in inclination state. (The ground is not flat).
(4) If the motor belt is loosened.
To Next Page
Loading...
