After repairing, be sure to make the following trial operation to see if
the washer operates normally.
Check Point Inspection & Judgement
1 Insulation resistance
Unplug the cord from the power outlet and turn on all the
timers. Then
measure the insulation resistance between the plug (both
of 2 pins) and
Grounding wire of the machine.
The measured value should be more than1M
In the following case, check sufficiently.
1)Replace the electrical part switch new ones.
2)Used in a moist place.
3)Used more than 5 years.
2 Safety designated
parts
Replace with the designated parts in the case the used
parts are not proper.
3 Wiring
Check to see if the lead wire is properly connected
without looseness or
Over tension and taping and setting are firmly performed.
washer.
4 Screws and Nuts
Check to see if the screws, nuts, etc are firmly tightened
and the screw locks are applied
5 Removal of useless
matter
Check to see if useless matters (Screws, bits of wire, etc.)
are left inside the machine.
6 Leakage of oil and
water
Check to see if oil or water leaks out around below-
spinning, gear box, motors
7 Power-cord
Check to see if the cord, the plug, the outlet etc., are not
damaged. Do not use table
Tape with multi-wiring
8 Level Installation. Check to see if the machine installed horizontally
24
7 CHECK POINT AFTER REPAIR
To Next Page
Loading...
