Service manual for Washing Machine Midea America Company
-------------------------------------------------------------------------------------------------------------------------------------------------------
－ 9 －
The LED digital display will show your remaining time for cycle selected. The initial display will be “--”
for some selected cycles. The LED will show selected delay time when setting the delay time.
4. Soak button
Press once to select soak function. Press again to cancel selection. This function is especially for
heavy soiled garments to remove stains more thoroughly by specifying additional time.
5. Extra rinse button
Press once to add an extra rinse into the washing program. Press again to cancel selection.
6. Start/pause button
Press once to start the program. Press again to pause the program. You can’t change any setting
except add a garment. Press again to restart the program.
7. Cycle status lights
The relative light will be lighted when the washer is in its washing program, say the soak will light
when the washer is operating in soak process. When the whole program is finished, the Done light
will flash.
8. Delay button
Delay the start of any cycle for up to 24 hours in one-hour increments. Displayed hour indicates the
time the wash will be started.
9. Soil level button
Press the button to select the soil level. Different soil level will result in different washing time.
10. Child lock
Press the “Soil level” and “Temp” buttons simultaneous for over 3 seconds to activate this function.
Press again for another 3 seconds to deactivate the function. All selection except the “Power” will be
out of function.
11. Temp button
Press the button to select the washing water temperature. The rinsing water temperature will always
keep in Tap Cold.
Hot - Whites and heavily soiled, colorfast items.
Warm - Colorfast items.
Cold - Brightly colored, very lightly soiled items.
Tap cold - Cold water with no warm water added.
12. Water Plus
Press once to increase one higher water level. Press again to cancel this function, If the water level is
already set to the highest, the level will not change.
13. Fabric Softener
If you are using fabric softener, Press this button to set dispenser to automatically add liquid fabric
softener to the load at the correct time.
To Next Page
Loading...
Need help?
General