Installation
Instructions
Your installation location should meet the following
requirements:
• Make sure that you install your unit on an even surface
to minimize noise and vibration.
• The unit must be installed near a grounded plug, and
the Collection Tray Drain (found on the back of the
unit) must be accessible.
• The unit should be located at least 12" (30 cm) from
the nearest wall to ensure proper air conditioning. The
horizontal louver blade should be at least 19.7" (50 cm)
away from obstacles.
• DO NOT cover the Intakes, Outlets or Remote Signal
Receptor of the unit, as this could cause damage to
the unit.
Choosing the Right Location
Recommended Installation
Note About Fluorinated Gasses
• This air-conditioning unit is a hermetically sealed unit that contains fluorinated
gasses. For specific information on the type of gas and the amount, please refer
to the relevant label on the unit itself.
• Service, maintenance and repair of this unit must be performed by a certified
technician.
• Product recycling must be done according to local regulations.
NOTE
All the illustrations in the manual are for explanation
purpose only. Your machine may be slightly
different.
The unit can be controlled by the unit control panel
alone or with the remote control. See the remote
control Instruction for details.
50cm
19.7inch
Installation Instructions
50cm
19.7inch
Page 10
To Next Page
Loading...
Need help?
General
