Press the "MODE" button until the "Dry" indicator
light comes on. In this mode, the fan speed or the
temperature cannot be adjusted. The fan motor
operates at auto speed.
The air conditioner will control room temperature
automatically round the temperature point set by
you. Under AUTO mode, you can not select the
fan speed.
COOL operation
Press the "MODE" button until the "COOL" indicator
light comes on.
Press the ADJUST buttons "+" or "-" to select your
desired room temperature. The temperature can be
set within a range of 16°C~30°C/60°F~86°F.
Press the "FAN SPEED" button to choose the fan
speed.
Get to know your AC
Electronic control operating instructions
1
7
8
2
56
4
3
1. POWER Button
2. MODE Function
Selects the appropriate operating mode. Each
time you press the button, a mode is selected in
a sequence that goes from AUTO, COOL, DRY,
FAN and HEAT (heat pump model only).
The mode indicator light illuminates under the
different mode settings.
Used to initiate the Wireless function. For the
first time to use Wireless function, press and
hold the power button for 3 seconds to initiate
the Wireless connection mode. The LED DISPLAY
shows 'AP' to indicate you can set Wireless
connection. If connection(router) is successful
within 8 minutes, the unit will exit Wireless
connection mode automatically and the Wireless
indicator illuminates.
If connection is failure within 8 minutes, the unit
exits Wireless connection mode automatically.
After Wireless connection is successful, you can
press and hold SWING and DOWN (-) buttons at
the same time for 3 seconds to turn off Wireless
function and the LED DISPLAY shows 'OF' for 3
seconds, press POWER and UP(+) buttons at the
same time to turn on Wireless function and the
LED DISPLAY shows 'On' for 3 seconds.
Power switch on/off.
21
DRY mode
AUTO mode
COOL mode
When you set the air conditioner to AUTO
mode, it will automatically select cooling,
heating (cooling only models without) or fan
onl
y operation depending on what
temperature you have selected and the
room temperature.
FAN mode
• When in FAN mode, press the FAN button to
choose the fan speed. The temperature can not
be adjusted.
HEAT operation(heat pump model only)
• Press the "MODE" button until the "HEAT"
indicator light comes on.
• Press the ADJUST buttons UP and DOWN
to select
your desired room temperature. The temperature
can be set within
a range of 16°C-30°C/60°F-86°F.
• Press the FAN button to choose the fan speed.
Note: For the fan speed can not be adjusted under
Keep windows and doors closed for the
best dehumidifying effect.
Under AUTO mode, both the AUTO
mode and the actual operation mode indicator
lights illuminate for some models.
When you restart the Wireless function, it may
take a period of time to connect to the network
automatically.
NOTE
NOTE
NOTE
HEAT mode.
To Next Page
Loading...
