Midea MERU280FEE02 - Page 17

13
• All temperature icons shine within 3s after power on, for power on at the first time,
the default set temperature is -20℃.
• After that every time you start the fridge, it will run in accordance with set t
temperature before last power off.
• After 30s of unmanned operation, the indicator light goes out. When adjusting the
gear, you need to press the key “A” to light up the indicator, and then press the key
“A” again to adjust the gear.
When the fridge power is on
• There is no door opening prompt tone; there is an open door alarm tone: when the
refrigerator door is not closed for two minutes after it is opened, the buzzer will
sound until the door is closed.Press the B button to cancel the buzzer alarm,it is
recommended to close the door in time.
Opening warning and alarm control
Display of normal running
• On the occurrence of a failure, the corresponding icons will give a combined blink.
lf no failure, the screen displays the seting temperature of the refrigerator room.
the error codes and types are shown as follows:
Temperature sensor of
refrigerator room fail
E5
E7
E10
E1
Defrosting sensor of
refrigerator room fail
Icon" "& icon"3 "shine at same time
E6
Icon" "& icon"4"shine at same time
Icon"2 "& icon"3 " shine at same time
Icon"2 "& icon"4 " shine at same time
Icon" "& icon"2 "shine at same time
Eror Code
DisplayError Description
Communication error
Ambient temperature sensor fail
Sticking problem with button
Freezer:
Temperature sensor of freezer
room fail
E5
E7
E9
E1
Defrosting sensor of freezer
room fail
Icon" "& icon"-22 "shine at same time
E6
Icon" "& icon"-20
"shine at same time
Icon"-24 "& icon"-18 " shine at same time
Icon"-24 "& icon"
-20 " shine at same time
Icon" "& icon"-24 "shine at same time
Eror Code
DisplayError Description
Communication error
Ambient temperature sensor fail
High temperaturealarm in
freezing chamber
E10
Sticking problem with button
Icon"-24 "& icon"-22 " shine at same time
Refrigerator:
EN