Buttons and Functions
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions section of this manual.
41
Model:
RG10A2(B2S)/BGEFU1
RG10A10(B2S)/BGEF(20-28
°C/68-82°F
)
RG10A(B2S)/BGEF, RG10A(B2S)/BGEFU1
( Fresh feature is not available)
(Cooling only models, AUTO mode and
HEAT mode are not available)
RG10A2(B2S)/BGCEFU1,
RG10A2(B2S)/BGCEF
Description
No.1
No.3
No.2
ON/OFF
Turns the unit on or off.
No.4
No.5
No.6
No.8
No.7
No.9
No.10
OK
Used to confirm the selected functions.
TEMP
Decreases temperature in 1°C (1°F) increments.
Min. temperature is 16°C (60°F).
TIMER
Set timer to turn unit on or off.
No.11
TEMP.
Increases temperature in 1°C (1°F) increments.
Max. temperature is 30°C (86°F).
NOTE: Press together & buttons at the same time for
3 seconds will alternate the temperature display between
the °C & °F.
No.12
No.13
No.14
SWING
Starts and stops the horizontal louver movement.
Hold down for 2 seconds to initiate vertical louver auto
swing feature(some units).
CLEAN
Used to start/stop the Self Clean or Active Clean function.
(Model dependent, please refer to the USER’S OPERATION &
INSTALLATION MANUAL for details)
Clean
LED
Turns indoor unit’s LED display and air conditioner buzzer on
and off(model dependent), which create a comfortable and
quiet environment.
LED
BOOST
Enables unit to reach preset temperature in shortest possible time.
Boost
BREEZE AWAY
This feature avoids direct air flow blowing on the body and
makes you feel indulging in silky coolness.
NTOE: This feature is available under cool, Fan and Dry mode only
1
4
2
3
5
8
9
12
6
7
10
11
13
14
Boost
Press this button to enter the energy efficient mode in a
sequence of following:
ECO/GEAR
ECO GEAR(75%) GEAR(50%) Previous setting mode ECO ......
Scrolls through operation modes as follows:
MODE
Auto
Cool Dry Heat Fan
NOTE:
HEAT mode is not supported by cooling only appliance.
Scrolls through operation functions as follows:
The selected symbol will flash on the display area,
press the OK button to confirm.
SET
Fresh/UV-C lamp( ) Sleep( ) Follow Me( ) AP mode( )
FAN SPEED
AU 20% 40% 60% 80% 100%
Press the TEMP or button to increase/decrease the fan
speed in 1% increments.
Selects fan speeds in the following order:
To Next Page
Loading...
