42
Buttons and Functions
Before you begin using your new air conditioner, make sure to familiarize yourself with its remote
control. The following is a brief introduction to the remote control itself. For instructions on how to
operate your air conditioner, refer to the How to Use Basic Functions section of this manual.
Model:
RG10A1(B2S)/BGEF
Description
No.1
No.3
No.2
ON/OFF
Turns the unit on or off.
No.4
No.5
No.6
No.8
No.7
No.9
No.10
OK
Used to confirm the selected functions.
TEMP
Decreases temperature in 1°C (1°F) increments.
Min. temperature is 16°C (60°F).
TIMER
Set timer to turn unit on or off.
No.11
TEMP.
Increases temperature in 1°C (1°F) increments.
Max. temperature is 30°C (86°F).
NOTE: Press together & buttons at the same time for
3 seconds will alternate the temperature display between
the °C & °F.
No.12
No.13
No.14
SWING
Starts and stops the horizontal louver movement.
Hold down for 2 seconds to initiate vertical louver auto
swing feature(some units).
CLEAN
Used to start/stop the Self Clean or Active Clean function.
(Model dependent, please refer to the USER’S OPERATION
& INSTALLATION MANUAL for details)
Clean
LED
Turns indoor unit’s LED display and air conditioner buzzer on
and off(model dependent), which create a comfortable and
quiet environment.
LED
BOOST
Enables unit to reach preset temperature in shortest possible time
Boost
air
magic
Air magic
Press to start/stop the Air magic or UV-C lamp feature
(model dependent), or both features(if any) at the same time.
1
4
2
3
5
8
9
12
6
7
10
11
13
14
Boost
Press this button to enter the energy efficient mode in a
sequence of following:
ECO/GEAR
ECO GEAR(75%) GEAR(50%) Previous setting mode ECO ......
Scrolls through operation modes as follows:
MODE
Auto
Cool Dry Heat Fan
NOTE:
HEAT mode is not supported by cooling only appliance.
Scrolls through operation functions as follows:
The selected symbol will flash on the display area,
press OK button to confirm
SET
Breeze Away( ) Sleep( ) Follow Me( )
AP mode( ) Breeze Away ...
FAN SPEED
AU 20% 40% 60% 80% 100%
Press the TEMP or button to increase/decrease the fan
speed in 1% increments.
Selects fan speeds in the following order:
To Next Page
Loading...
