Sleep function( ) :
The SLEEP function is used to decrease
energy use while you sleep (and don’t need
the same temperature settings to stay
comfortable). This function can only be
activated via remote control.
NOTE: The SLEEP function is not available
in FAN or DRY mode.
This feature avoids direct air flow blowing
on the body and makes you feel indulging
in silky coolness.
For the detail, see“ sleep operation” in
“USER S MANUAL ”
NOTE: This feature is available under cool,
Fan and Dry mode only.
Breeze Away function( ) (some units) :
FRESH/UV-C lamp function( ) (some units) :
When this function is selected, the Ionizer or
UV-C lamp(model dependent) will be activated.
If has both features, these two features will be
activated at the same time. This function will
help to purify the air in the room.
49
SET function
or
SET
SET
OK
Press the SET button to enter the function setting, then press SET button or TEMP or TEMP
button to select the desired function. The selected symbol will flash on the display area,
press the OK button to confirm.
To cancel the selected function, just perform the same procedures as above.
Press the SET button to scroll through operation functions as follows:
Follow me function( ):
The FOLLOW ME function enables the remote
control to measure the temperature at its
current location and send this signal to the air
conditioner every 3 minutes interval. When
using AUTO, COOL or HEAT modes, measuring
ambient temperature from the remote control
(instead of from the indoor unit itself) will enable
the air conditioner to optimize the temperature
around you and ensure maximum comfort.
If the memory feature is stopped, “OF”
displays for 3 seconds on the screen.
While the memory feature is activated,
press the ON/OFF button, shift the mode
or power failure will not cancel the Follow
me function.
NOTE: Press and hold Boost button for
seven seconds to start/stop memory
feature of Follow Me function.
If the memory feature is activated, “On”
displays for 3 seconds on the screen.
AP function( )(some units) :
Choose AP mode to do wireless network
configuration. For some units, it doesn’t
work by pressing the SET button. To enter
the AP mode, continuously press the LED
button seven times in 10 seconds.
Breeze Away ( ) Fresh/UV-C lamp ( ) Sleep( ) Follow Me( ) AP mode ( )
[ ]: If your remote controller has Breeze Away button or air magic button, you can not use the SET
button to select the Breeze Away or Fresh/UV-C lamp feature.
*
*
*
*
.
How to Use Advanced Functions
To Next Page
Loading...
