CHANGE THE DRYER VENT LOCATION
Your new dryer is shipped to vent to the rear. It can also be configured to
vent to he bottom or left side (see from the front).
An Adapter kit is standard component which you can purchase from local
market.
Tools and materials you will need
Duct tape
Phillips screwdriver
Rigid or UL-listed
flexible metal
4'' (10.2 cm) duct
Elbow 4'' (10.2 cm)
Gloves
1. Remove the rear exhaust retaining screws. Pull out the exhaust duct.
Rear
Exhaust Duct
Retaining
Screw
Option 1: Side venting
2. ress P the tabs on the knockout and carefully remove the knockout for
t he desired vent opening.
Press the adapter duct onto the blower housing of the dryer as shown.
Knockout
Adapter
Duct
To Next Page
Loading...
Need help?
General
