MCAC-UTSM-2008-05 Wiring
Installation 95
For MUB-18HRDN1-Q:
Outdoor unit: Indoor unit:
Number
① ② ③ ④ ⑤ ⑥
Area of the connecting wiring
(mm
2
)
4×0.5 3×2.5 4×1.5 4×0.5 2×2.5 3×1.5
6.2 For MOU-12HDN1
Caution:
1) The appliance shall be installed in accordance with national wiring regulations.
2) The air conditioner should use separate power supply with rated voltage.
3) The external power supply to the air conditioner should have ground wiring, which is linked to the
ground wiring of the indoor and outdoor unit.
4) The wiring work should be done by qualified persons according to circuit drawing.
5) An all-pole disconnection device which has at least 3mm separation distance in all pole and a residual
current device (RCD) with the rating of above 10mA shall be incorporated in the fixed wiring according
to the national rule.
6) Be sure to locate the power wiring and the signal wring well to avoid cross-disturbance.
7) Do not turn on the power until you have checked carefully after wiring.
To Next Page
Loading...
