Page 11
Installation
Instructions
Tools Needed
-Medium Philips screwdriver; -Tape measure or ruler; -Knife or scissors;
-Saw (On some models, to shorten window adaptor for narrow windows)
Accessories
Name of Accessories
Qty.
Shape
Name of Accessories
Qty.
Shape
1 pc
1 pc(*)
Window Slider A
1 pc(*)
1 pc
Anti-hot Air Inlet Adaptor
1 pc(*)
1 pc(*)
1 pc
1 pc
1 pc
1 pc(*)
1 pc
2 pc
1 pc
Window Slider B
Retainer plate
Window Slider C
Window Slider D
Window Slider E
4 pc
Foam Seal A (Adhesive)
Air Hose Insulator
(only for heat pump model)
2 pc
Foam Seal B (Adhesive)
Bolt
1 set
Security Bracket and 2 Screws
1 pc
Drain Hose
1 pc(*)
Power Cord Buckle
(only for cooling model)
ON /OFF
TEM P
SHO R T
CU T
TIME R
ON
TIME R
OFF
MO DE
FAN
SLE EP
SW ING
LED
1 set
Remote Controller and Battery
(only for remote control models)
2 pc
8 pc
Foam Seal C (Non-adhesive)
1 pc(*)
Drain Hose Adaptor
(only for heat pump model)
Exhuast Adaptor Module C
Exhuast Adaptor Module B
Exhuast Adaptor Module A
NOTE: Items with (*) are on some models. Slight variations in design may occur.
Why is the cooling capacity lower on newer models than on older units?
number means more cooling power for a larger room. (Be sure you are comparing only newer
models to each other- older models may appear to have a higher capacity, but are actually the
same). Be sure to “size up” if your portable air conditioner will be placed in a very sunny room, in a
kitchen, or in a room with high ceilings. After you’ve found the right cooling capacity or your
room, you can look at other features.
Federal regulations require manufacturers to calculate cooling capacity based on a specific test
procedure, which was changed just this year. Models manufactured before 2017 were tested under
a different procedure and cooling capacity is measured differently than in prior years’models. So,
while the BTUs may be lower, the actual cooling capacity of the air conditioners has not changed.
What is SACC ?
SACC is the representative value of Seasonally Adjusted Cooling Capacity, in Btu/h, as determined
in accordance with the DOE test procedure at title 10 Code of Federal Regulations (CFR) 430,
subpart B, appendix CC and applicable sampling plans.
1 Screw(on Exhuast Adaptor)
Ribbon
(only for heat pump model)
2 pc(*)
Insulator
To Next Page
Loading...
Need help?
General
