Page 14
Operating Instructions
Control Panel Features
NOTE: The following control panels
are for explanation purpose only. The control panel of the unit you
purchased may be slightly different according to the models. Your machine may not contain some indicators or
buttons. The actual shape shall prevail.
Operating
Instructions
Swing/Wireless button
Used to initiate the Auto swing feature. When
the operation is ON, press the SWING button
can stop the louver at the desired angle.
Used to initiate the Wireless function. For the
first time to use Wireless function, press and
hold the SWING button for 3 seconds to initiate
the Wireless connection mode. The LED DISPLAY
shows 'AP'(The wireless light illuminates) to
indicate you can set Wireless connection. If
connection(router) is successful within 8 minutes,
the unit will exit Wireless connection mode
automatically and the Wireless indicator illuminates.
If connection is failure within 8 minutes, the unit
exits Wireless connection mode automatically.
After Wireless connection is successful, you can
press and hold SWING button and DOWN( )
button for 3 seconds to turn off Wireless function
and the LED DISPLAY shows 'OF' for 3 seconds,
press SWING button and UP( ) button to turn
on Wireless function and the LED DISPLAY shows
'On' for 3 seconds.
NOTE: When you restart the Wireless function,
it may take a period of time to connect to the
network automatically.
Timer button
Used to initiate the AUTO ON start time and
AUTO OFF stop time program, in conjuction
with the + & - buttons. The timer on/off
indicator light illuminates under the timer on/
off settings.
Press and hold on TIMER button for 3 seconds
to cancel timing function.
Mode button
DRY, FAN and HEAT (cooling only models
without). The mode indicator light illuminates
under the different mode settings.
Selects the appropriate operating mode. Each
time you press the button, a mode is selected
in a sequence that goes from AUTO, COOL,
Up ( ) and Down ( ) buttons
Used to adjust (increasing/decreasing) temperature
settings in 1°C/1°F increments in a range of
16°C/60°F to 30°C/86°Fo r the TIMER setting in a
range of 0~24hrs.
NOTE: The control is capable of displaying
temperature in degrees Fahrenheit or degrees
Celsius. To convert from one to the other, press
and hold the Up and Down buttons at the same
time for 3 seconds.
Fan/Continuous fan button
Control the fan speed. Press to select the fan
speed in four steps-AUTO, LOW, MED, and HIGH.
The fan speed indicator light illuminates under
different fan settings.
NOTE: On auto and dry mode, the fan speed
cannot be selected.
On cool or dry mode, press and hold FAN button
for 3 seconds to
initiate continuous fan feature and
the continuous fan light illumiantes.
Press and hold
FAN button for 3 seconds again to stop
continuous
fan feature and
the continuous fan light turns dark.
ON
OFF
To Next Page
Loading...
Need help?
General
