Operation
11
SWING
TIMER MODE
FAN SLEEP ON/OFF
ION(Press 3s)
Swing button
Sleep/Eco button
Used to initiate the Auto swing feature.
When the operation is ON, press the
SWING button can stop the louver at
the desired angle.
Used to initiate the SLEEP/ECO
operation.
Timer button
Used to initiate the AUTO ON start
time and AUTO OFF stop time
program, in conjuction with the + & -
buttons. The timer on/off indicator
light illuminates under the timer
on/off settings.
Mode button
Selects the appropriate operating mode. Each time
you press the button, a mode is selected in a sequence
that goes from AUTO, COOL, DRY, FAN and HEAT
(cooling only models without).The mode indicator light
illuminates under the different mode settings.
Power button
Power switch on/off.
Up (+) and Down (-) buttons
Used to adjust (increasing/decreasing) temperature
settings in 1°C/1°F(or 2°F) increments in a range of
17°C/62°F to 30°C/86°F(or 88°F or the TIMER setting
in a range of 0~24hrs.
NOTE: The control is capable of displaying temperature
in degrees Fahrenheit or degrees Celsius. To convert
from one to the other, press and hold the Up and Down
buttons at the same time for 3 seconds.
SWING
TIMER
MODE
SLEEP
ON/OFF
FAN
ION(Press 3s)
Fan/Ion button(Ion is optional)
Control the fan speed. Press to select the
fan speed in four steps-LOW, MID, HIGH
and AUTO. The fan speed indicator light
illuminates under different fan settings
except AUTO speed. When select AUTO
fan speed, all the fan indicator lights turn
dark.
NOTE: Press this button for 3 seconds to
initiate ION feature. The ion generator is
energized and will help to remove pollen
and impurities from the air, and trap them
in the filter. Press it for 3 seconds again to
stop the ION feature.
To Next Page
Loading...
